TUR centralizers pulled through a FMC sub-mudline receptacle with no issues

CASE STUDY TUR centralizers pulled through a FMC sub-mudline receptacle with no issues

In this Deepwater well in Malaysia, TUR centralizers are pulled through a FMC sub-mudline receptacle with a 17.183" restriction with no issues.

THE CHALLENGE

A vertical (2 degree) well with a depth of 1,110 in Malaysia. A FMC sub-mudline receptacle with a restriction of 17.183” was in the 20” casing at ~920m. 

THE SOLUTION

The customer ran 600m of 16” liner with 1 Centek TUR 16" x 20" centralizer per 4 joints in open hole (based on inclinations <1deg). Aside from the initial push required to get the shoe centralizer into the wellhead, no issues were observed running the centralizers through the wellhead and the SML hanger restriction. Unfortunately a problem was encountered when landing the SML hanger in the receptacle and the liner had to be pulled back.The custmer encountered no problems pulling all the centralizers back through the 17.183” restriction, subsequently re-running them through the restriction and into the hole again.

THE RESULT

The liner was not pulled back far enough to verify the condition of any of the centralizers and stop collars but there was no Centek equipment bunched up underneath the hanger proving that all centralizer equipment stayed in place and worked as intended. 

CUSTOMER TESTIMONIAL

Again, Centek equipment has shown itself to be well-suited to a difficult application 

Luke Morris, Conoco Phillips